I’m considering ordering one of these kits as I have a fair bit of copper pipe to work with in the next 12 months, which of these kits would be suitable for standard UK copper piping?
M12 ONEHPT-202C M-SET, M12 ONEHPT-202C V-SET**,** M12 ONEHPT-202C TH-SET**, or** M12 ONEHPT-202C U-SET**.**
I want either a mitre saw, or the gen3 circular saw, main use will be cutting laminate and skirting and architraves. not sure if the circular saw would be suitable for this, any advice appreciated.
*edit* since a lot of replies seem to be raging about the tools looking brand new I’ll clear that bit up, they’ve all, aside from the router, been used, I’m just ocd and clean them after every use.
is there a rubber boot available for the gen2 similar to this…
https://uk.milwaukeetool.eu/en-gb/rubber-sleeves-for-grinders/rubber-sleeves-for-grinders/