u/J_bravo_

I have a set of Dali Oberon 1C's that are run from the Dali Soundhub (full size model, not compact). The Soundhub has an LFE output.

I'd bought a SVS PB-1000 and hooked it up (LFE to LFE) but the signal is much too low, even with the gain turned all the way up. From what I understand the voltage output from the Soundhub is too low for the sensitivity of the SVS.

Any recommendations for a sub that can accept low voltage input? Don't want to spend over €500, used is fine. The SVS was great on paper and sounds insane when connected to a different source, shame it doesn't work with the Soundhub.

After a snapped cable I replaced the window mechanism on the right side door of my TTS (8J). Install went smoothly, everything seems to line up but the window doesn't seal and I get a draft at anything over 60mph.

I've played around with the various adjustments, assumed having the glass as high as possible would do the trick but no luck. The adjusters on the rails that attach to the door have the glass pointing as inwards as possible and the glass is as high as possible through both the adjustment screws (the ones that require allen keys) as well as on the plastic holder that has the bolt going through the glass. Have also tried lower / more upright settings and no luck.

Any ideas?

Test drove a 335i (2011) today, noticed something about the handling. Front turn is fine, but the rear doesn’t seem to follow until a fraction later. Which it does, but it doesn’t feel entirely natural. This was at brisk pace but wasn’t trying to break out the rear or anything. Quite noticeable on shorter turns like roundabouts.

Any idea what this could be?

My Audi did something similar after I put the new anti tool bar on its tighter setting. Could that be related? The 335i has a few mods, but beyond the wheels and Billstein B8 (presumably from the B12 kit) I’m not sure nor is the dealer.