u/Mariobrouz

I'm venturing into the challenge of multi-color on the same layer as if I had AMS but manually

Does anyone know of any good tutorials, tips, or advice for achieving good quality multicolor results?

Because I've tried it, but it leaves me with too much subtraction and over-extrusion.

As you can see in the video, I've already made several attempts, but with this over-extrusion problem, the nozzle hits the print a lot and ends up generating a lot of vibrations, to the point that it becomes misaligned and completely ruins the print. I've also already used a lower extrusion width and reduced the flow for the first layer, and I don't know what else to do.

Hey everyone, I was checking my bed, but both the local IP interface and the printer interface are giving me this data when I do the auto-leveling.

I asked Gemini and chatgpt, but I'm not sure how to fix it or if it's even worth fixing. I'm very anxious about making everything as perfect as possible, and now that I know about this, I can't stop looking for a way to balance it. So is there any way to fix this on this printer?

All this time, I've been printing fine until today; I even have a print job in progress right now and everything is perfect.

I also tested the Z-axis with two identical objects, and it seems everything is level, and all the screws have been checked and tightened.