u/Master-Ad-191

My trial run (red fabric) looked great. I’ve got the shirt hooped this time and it seems so sparse. I have double layer cut away stabilizer underneath. Is there any way to save it? I’m a newbie.

1. Could I put water soluble stabilizer on top and run it again without unhooping?

2. Could I unhoop, seam ripper, use adhesive spray to spray the fabric to the stabilizer and try again?

Any other suggestions gladly welcome!

New build. Was told the original color was Agreeable Gray by Sherman Williams. It is clearly not as my patch is obviously different (yes it is dry in the photo). Any ideas? My entire house is this color.

Edit: the builder was not entirely sure this was the right paint color. It was his best guess.

Test run for a design I’d like to make for my daughter. I used a tear away stabilizer and a thin cotton scrap fabric. By the end it had shifted slightly so the outline on Nemo didn’t quite line up. I see the pull in the fabric but I initially tried to hoop as tight as I could. Does using cut away stabilizer help this?

I wasnt thrilled on the letters either. There was a pull in the thread on the M but not sure if this was stabilizer related. I used a font built into Ember for this. Is this acceptable? Or better to download and upload a separate font?

Would love any and all advice!!

Help! I just got this machine. I keep getting this error and there is nothing on the troubleshoot guide about this. It’s almost like the grind sensor is not working? Any help?