I want to install a mini sub (WS-TS010A) to the rear speaker connection. I believe it will fail the check and the uconnect will see it as open and not send signal. (It's a camper van so rear speakers wouldn't really be heard and are not worth it)
Any cheap device or trick? I have 4ohm speakers to use to activate but didn't want to leave them connected, only the sub.
I know the uconnect is funny about load sensing. I know people use 4ohm to activate and then switch them out, but what about activating with 4ohm speakers then swapping them out for a subwoofer? Would that fail some check and turn the rear speakers back off?
Trying to decide if I should inspect capacitors or Swap for a CRT emudriver compatible GPU.
I get these issues with DVI-I out or with HDMI/DP to VGA adapter. I'm on Newest drivers on Titan x Maxwell (but got the same artifacts on older drivers) Phillips 34PW850H37F Widescreen HD CRT TV.
Z97 OC formula. It has 6 pcie slots that share with some sata ports so it's confusing.
I'm finishing an old parts build and having some trouble. I have a GPU in the top pcie slot (pcie1). I tried the sound card in slot 5 (the 2nd to last small black slot) and it's not being recognized (pic 3).
I only have one ssd installed to sata 0 and have no m.2. what slot should I try next? (Heat and airflow on the GPU or PSU are not an issue.)
Any creative ideas? The way the door closes means a wind deflector does nothing for the door gap. I've tried adding seals/strips/backing but seems about the same noise level. Honestly the deflector may have made it worse.
Only on one side. The mower wouldn't start either. So I took the wheel off and tried to rotate the gear manually. It got a bit easier after getting it started, then I put the wheel back on and mower works again. Easy fix but probably temporary.
What do I need to grease or fix to prevent it and help it rotate in the future?
Edit: mower runs after manually turning gear, but only one back wheel is propelled and the wheels were locking up intermittently.
I ended up taking off both wheels and noticed the gear was about to fall off one side and had lost it's locking washer. I put it all back together with some new locking washers. Good to go. While I was at it I bought some new tires on Amazon because my back ones were bald.
Z97 oc formula with overclocked i5 4690k with 16gb ddr3. It would need a hard drive and GPU to run again. Don't want to throw it away but it's been sitting for a while... Thanks