u/Middle_Basis2816

4 engines done, on to the next row of engines.

This gives a great idea how big this thing will be :)

• First image I forgot to repair the model when PhotonWorkshop said it needed fixing ( it always says so with every model :)
• Second, in my haste I forgot to add draining holes in the model, and suction made a mess of it.

These are big parts and expensive failures :/

• First image I forgot to repair the model when PhotonWorkshop said it needed fixing ( it always says so with every model :)
• Second, in my haste I forgot to add draining holes in the model, and suction made a mess of it.

These are big parts and expensive failures :/

• First image I forgot to repair the model when PhotonWorkshop said it needed fixing ( it always says so with every model :)
• Second, in my haste I forgot to add draining holes in the model, and suction made a mess of it.

These are big parts and expensive failures :/

The main parts of the #1 engine are complete.

Did I say it is going to be big ?

And 21 hours later, we have an engine part, this thing is going to be big :)

I cut an engine parts (1 of 11) into 2 parts, to fit my printer.

made the wall 2.5mm wall thick, and it would take about 22H to print, will start early tomorrow morning, so I can keep an eye on it, and add resin when needed.

Wish me luck :)

I really want to try and print the Alain Rivard Blockade runner at studio scale.

Although the inside structure is fine for smaller models, at this scale the it becomes really heavy and takes too much resin, so first job is to clean the insides so can hollow the parts with my own wall thickness.

This will take some time :)