u/Mitaa11

What could be the problem? This is Puck, presupported mini from Cones of Calibration, Cones test came out kinda good (one index cone on success side didn't fully connect, rest of the was good). My settings are:
Layer Height 0,03mm
Exposure Time: 12,7s
Light off Delay: 13s
Speed: 1mm/s
Lift Distance: 6mm
I know I can make heavier supports and tips on my custom minis, but it worries me that these weren't close to touching
Edit: I forgot to mention that printer is older, uses RGB LCD screen.

Hi all, posted on here yesterday, thanks for all the info. Did some of the things u guys and came back with more test results, which i don't really understand. On some of the tests it seems that it's overexposed but yet all the cones failed and it didn't even print the sword.
I'm using preowned Anycubic Photon 5.5 (I guess its S), here are my print settings:
- Layer Height: 0,035mm
- Bottom Layer Count: 8
- Exposure Time: 15,5s
- Bottom Exposure Time: 60s
- Light-Off Delay: 6s
- (Bottom) Lift Distance: 6mm
- (Bottom) Lift Speed: 150mm/min
- (Bottom) Retract Speed: 180mm/min
With Anycubic Plant Based Resin 2.0 (Grey)

Does any one has any idea on what print settings should I try next and should i just do Cones of Calibration?

Just started with resin printing and bought preowned and used Anycubic Photon 5.5. I will post validation test in comments, its overexposed on purpose and it fills more of the side lines and square now but still not enough, could this be FEP film problem, should it be changed?