Got the ECS Tuning handbrake cover installed today, the oem one is a real pain to get off. The profile around the button is a bit off but besides that I can't complain, definitily better than the peeling leather on the oem one!
Does anyone know how to remove the hand trim on the handbag lever? The button flew off today so I'm going to glue it on and replace this trim while I'm here.
Somewhere in the last 30 minutes of a 10 hour print I got a spaghetti failure, 2 of the tall (240mm) prints had come off the build plate (one of them in the photos above) and it looks like the nozzle had plunged into it? The other 2 pieces are fine and one was still attached to the build plate. I know this is close to the z limit but what would have caused this? I think the spaghetti failure is the least of my worries 😬
​
Thankfully this was just a test print and its still usable for a mock up...