Best time to burn through keys?
On Day 15, just opened Gear Dungeons and the illusion place. Do the keys reset when the timer counts down or should I save them?
u/Nintura — 10 hours ago
3.5 minutes per 8x speed GR2-17 auto run?
It took me a few hours to auto run 50 runs of 17 at 8x speed.... anyone know why? It didnt take me that long to beat the level itself
u/Nintura — 1 day ago
How do you all rate your heroes or figure out who is best at what?
Because some heroes get a remake, how do you know who is best at what on your teams? What do you do to rate your heroes to know where best to use them?
u/Nintura — 1 day ago
Dark elf hydra. Color scheme ideas?
Had chat give me some ideas to look at. Anything else people can think of?
u/Nintura — 5 days ago
Umm im kinda freaking out here
I just started, today was my wukong pull and i did get him at 200 but I also got what i feel is the best healer and in my current faction? Is she new? How do i build her?
u/Nintura — 9 days ago
Imported the Item codes, but how do you use them?
I have the codes saved, but how do I use them and what exactly do they do? Every video is forever long and goes over a ton of information that doesnt quite answer my questions
u/Nintura — 12 days ago
Pull for anything this weekend or keep saving?
Today is day 6. Keep saving for wukong or pull on the higher drop rate weekend?
u/Nintura — 13 days ago
New. Have enough 5* shards to upgrade one to 6*. Any of these worth doing or save for something soon?
u/Nintura — 14 days ago
▲ 16 r/PrintedWarhammer
Printed dark elves
Working on a chariot that ill magnetize so i can remove the crew or extra cold ones
u/Nintura — 18 days ago
▲ 20 r/WarhammerFantasy
Need suggestions on a paint scheme for my dark elves war hydra
Finally got the old ral partha hydra that my dad painted when i was a kid (original was stolen by a friend….) and Im unsure of a paint scheme to go with my dark elves. Suggestions?
u/Nintura — 23 days ago
▲ 1 r/resinprinting
Anyone know what causes this issue?
Switched to phrozon mixed and this issue came up even after using recommended settings. Its like it filled in space and layers came undone. Ive printed about 20 others that had no issues, but the last two have done this
2.5 seconds exposure time
Light off delay 1.2 seconds
Lift speed reduced to 320 mm min
Retract speed reduced to 240 mm min
u/Nintura — 1 month ago