u/No-Jellyfish5883

I havnt touched my airbrush in about 5 years but decided now was the time if I'm going to do this big print any justice,

After adding some hot staples as re-enforcement in the vertical branch, Another quick coat of filler over the holes, More primer for a quick blend and here we are,

Finished the branch this evening and waiting on some new greens / grays coming for the chameleon itself 👌🏽 Replication of a Female Jacksons / Hybrid

As you may know, I'm a affiliate of Sunlu so obviously printed with Sunlu PLA+

On my Snapmaker U1s (Purely for the bed size)

680mm High

480mm Wide Base

Model was off CGTRADER

Split using Luban

Assembled using quick cure 2 part resin & hot staples 😏

I havnt touched my airbrush in about 5 years but decided now was the time if I'm going to do this big print any justice,

After adding some hot staples as re-enforcement in the vertical branch, Another quick coat of filler over the holes, More primer for a quick blend and here we are,

Finished the branch this evening and waiting on some new greens / grays coming for the chameleon itself 👌🏽 Replication of a Female Jacksons / Hybrid

As you may know, I'm a affiliate of Sunlu so obviously printed with Sunlu PLA+

On my Snapmaker U1s (Purely for the bed size)

680mm High

480mm Wide Base

Model was off CGTRADER

Split using Luban

Assembled using quick cure 2 part resin & hot staples 😏

You can get a cheeky discount on sunlus website using my code during checkout: RZYKFJZULV

I havnt touched my airbrush in about 5 years but decided now was the time if I'm going to do this big print any justice,

After adding some hot staples as re-enforcement in the vertical branch, Another quick coat of filler over the holes, More primer for a quick blend and here we are,

Finished the branch this evening and waiting on some new greens / grays coming for the chameleon itself 👌🏽 Replication of a Female Jacksons / Hybrid

As you may know, I'm a affiliate of Sunlu so obviously printed with Sunlu PLA+

On my Snapmaker U1s (Purely for the bed size)

680mm High

480mm Wide Base

Model was off CGTRADER

Split using Luban

Assembled using quick cure 2 part resin & hot staples 😏

You can get a cheeky discount on sunlus website using my code during checkout: RZYKFJZULV

Even though the base has been filled with a weight stabliser it's still a lot of auqward balanced weight sitting on that last joint (between the gray and white on the vertical branch) so will pop a few hot staples in (alongside adhisive) when im ready to join them together,

Although, It makes sense doing most of the filler / sanding work with it in 2 parts and leaving that joint until last, Just to make it easier to move around for sanding,

I was originally looking for a male panther chameleon, If you know me personally there one of my favourites to keep but couldn't find something realistic and the same pose (base / branch etc) so went for a female Jacksons / hybrid instead,

The base part is going to be covered in a soil / coir / bark mix, Just to make it more realistic so went over the top giving it a bit texture with filler,

Standing at 680mm Tall

480mm~ wide base

Sunlu PLA+

All 6 wall / 10% gyroid

Printed on the U1s

Scaled and split with Luban,

I'm not sure on the total kg yet, I ran off a few half spools then onto the big rolls but estimated around 6kg / total weight around 10kg~ with stabliser,

It's going to take me a few days to filler and sand as there's a few auqward bits but shall pop a update up when I'm working on it 💪🏽