u/PossibleMorning7135

I recently started getting these an hour or so into any print. I am confused, because the printer will happily idle at 250 for hours on end. Print temp is 235.

H500, and a civilian UH-60A at KCHD. All we need is a CH-47, and we will have all 3 airframes flown by the 160th. If someone has the ability to bring a Chinook to KCHD, feel free to drop by.

My Ender 3 Pro keeps clogging after awhile. The filament piece that I pull out of the hot end is always a constant, smooth diameter at the bottom, with a narrower section up top still showing the marks from the extruder. I fixed the heating issue I had not long ago (motherboard issue, and went for some upgraded firmware). It does have a direct drive modification.

My Ender 3 Pro (4.2.7) keeps showing this warning screen between 210 and 220 C. The thermistor is good, I checked it before installing it. I did accidentally pinch the wires with the screw but have since backed it out, and moved the wires. Any other idea what could be wrong?