My estimated time to cool is a lot different than actual time.
It said 40 mins but the trend shows system only ran 26 mins so how is time to cool calculated and why is it off that much
I run a total manual heat and cool, no schedule with manual hold until I change so should I turn off Eco+ and Smart Recovery
I want to get a humidity gage to check the accuracy of my Ecobee3 lite, I have read where it can be off calibration a lot
Here are two I’m looking at
My new ac has been in for several weeks and seems to be doing a decent job, run times look ok , we keep it set to 73 during the day and 68 at night with a 1 deg span so I have to ask does all look normal.
Just had a new inside evap coil and outside condenser replaced because my evaporator coil had a really bad leak along with a capacitor going out and compressor was pulling really high amps ( most likely burned up because no refrigerant when checked like completely no charge for a few days, it was a low end builder box so I stepped up to an Amanna with a 10/10 warranty
To me the cycle times look short on the last part of the trend, it’s only been in 24 hrs
Im getting 15-20 min run times so not two complete cycles in an hour which I think is to few of cycles
The new Amana is supposed to be a huge upgrade from the one that went out