u/SLOPPENHEIIMER

ive talked to bambu support for weeeeeeks and they only have given me the solution to buy new feeder funnels on my ams lite. im just curious if anyone else has issues with 250g spools not loading by it self on their a1 / ams lite. i also tried to swap over the filament from the 250g spool to a 1kg spool and it still does not feed. its sunlu pla filament so maybe its their stuff? i have 2 spools of some random petg on there and no issues at all.

What's up guys. My girlfriend gave me a set of button down 4 ski racks and they don't have the mounts to secure them to my cross bars. I'm wondering if anyone has replaced theirs and what they used.

What's up guys. I just saw some random video on Instagram where a guy had like a lightning ⚡ effect on boot but then changed to a different lightning profile/ effect when it's booted up and running. Is there a way to do this in icue? I tried the device memory mode and it did save what I wanted instead of just the rainbow rgb it normally does. But then it stayed there and didn't switch when booted. I have Corsair ram and the lightning triangles. Any help would be great.

What's up guys. So my printer has pretty much always done this. But I have two 32 gig sd cards I use on my printer. They are no where near full with files / logs etc. But it seems like after maybe 50 ish files on the card studio and the other it self just doesn't load them past a certain point. It's just grayed out and says zero minutes 0 grams to print. And when I pull the SD card out to see if it's full on my computer. There's 27 gigs free. Is there a limit the printer can handle to load? Even if I restart it power cycle all of that stuff. It's the same deal. Even deleting all the cache and logs it's the same deal. Anyone else have this issue / fix for it?

Can anyone help me with the default bottom of list issue? So when I search my entire library. It always defaults to the bottom of the list. Not the top. I use the sort by artists descending. But say I want to search for the artist A-ha. Or Alicia keys. It defaults me to the bottom. Not the top. Very annoying hahaha.

What's up guys. I've messed with a few different body post types and magnets for my jlu 3d printing and none of them seem to be strong enough. Even at 100 percent Infill. Was wondering if anyone had a better file / better option to mount the rear body. The goal is to have the whole body be magnetic.

What's up guys. So I've had the extruder clicking before and usually throwing a new nozzle in fixes it. This time it didn't. I just got a brand new nozzle / hot end on and it's still clicking when extruding. I took the hot end off and tightened up the 3 screws holding the nozzle heater on and they were pretty snug but still getting the clicking. Not sure what else I'm forgetting to do. Any help guys?

What's up guys. After I put in my aftermarket stereo I was getting bored with the factory sound so I just threw a sub box I had laying around in the back and wired it all up and it works fine. But my issue is where is there a port on the passenger side firewall to pass the power wire through. I also need to find a way to route the RCA wires as well. Just wondering if anyone has added a sub to their rig and how you hid the wires. Thanks guys.