u/Sad_Low3239

First one is used against spiders both big and small. the third photo I removed all the frame foundations to see the inside better. forgot to mention I added some stairs and wire to make it harder for the smaller spiders to get inside, and make it easier to get to the floor foundation part.

second one I've shown as is, and then after I replaced the walls with 1 and 2 hole variants.

all are currently floating but normally they would be connected with the ground. if you really want you can place and nudge them to the creatures from pretty far away.

asked about here

edit I put a updated version of the tower in comments.

Hopefully he likes the message 😭. They grow up way too fast

edit y'all are weird on your AI hang-ups lol

I mean, I used chatgpt to get rid of the background from a sticker I found online, and I use a free photo editor Pixlr to make it. used Pixlr for the font bubble also. background is just a bunch of gradients

edit it was this sticker

turning off notifications for this. apparently I had linked the store sticker? and not the general Google search results.. and that's a specific issue 🤦‍♂️ I don't care anymore to those that were nice thank you, glad someone else appreciated this in some way, and gets motivated to do whatever.

my son loved it and I'm focusing on that.

installing an above ground, 20 x 14 Bestway pool from Costco. we've drained this twice and tried re leveling (by scratching not adding) material and there is still slope. pad was made using 0-3" crusher mix stone 1' deep, and 0.5" of 0-¾" + screening sand for the top, all compacted with a roller (I work asphalt borrowed from them.)

we let the water fill to remove the wrinkles, and it's clearly preferring one of the corners. the photo with the highest waterline is the low side, the other two corners look like the second darkest photo, and the bright last one is the high side.

I've been watching videos on YouTube about correcting this, and how to drain (since we needed to twice) and everyone seems to have \*some\* greater than zero slope. my digital level is reading 0.8 when I read it from the high corner into the low one (when filled - I'm using an aluminum straight edge) and the width is reading 0.5 and the length is reading 0.7

what's the good the bad and the ugly if we go with this?

if corrections are absolutely needed, what's the best way to go about correcting this? do I scratch left and right or up and down? or corner to corner?

It wasn't because he bit my finger though.

She said this is what they give to our local zoo for their reptile and amphibian inhabitants, and they told me to give it to my toads via syringe. confirmed 100% she knows I have toads, and not herbivores. Google AI is telling me the fiber in this will kill my toad.

advice?