How do I assign filament from 2nd CFS? The first CFS I use for PETG and 2nd for PLA. I want to prototye a print in PLA and it appears as slot 2A in Creality Print. But I can't assign any spool from the 2nd CFS, it just shows 1-4 (A-D on CFS 1).
I'm thinking of getting a 2nd CFS and building a side stand for them. Has anyone tried increasing the PTFE tube length and mounting the Hub somewhere more accessible?
Printing a gag sign for a cheap motel model in PLA. I've calibrated all the filaments in the CFS and even slowed down the print on the lettering layer. At this rate, I'm just going to prime and paint. But for future use, what am I doing wrong? Creality K2 Pro w/CFS, Creality print, Overture PLA except the black (label fell off). Temp from per calibration is from 190 to 210.
No idea where these go. Short one on the right was found on the rail support front right. Not even a hint of locktight. May have to wait until something falls off.
Under the right-hand side under print profiles, there is a list of ... related prints? How do I get to those, other than clicking the link to the author or copy-pasting the title and search. I think I'm missing something really basic.
I can't successfully print a stack of open grid boards. First board prints beautifully but stringing first occurs at the interface layer. After that layer errors just compound. I've tried printing in pure PETG and PETG with PLA interface layer.
This is the top internal surface, which had hybrid tree supports. The rest of the print is beautiful, with almost invisible layer lines. This is a functional part that needs to be clean(er).
My only other solution is to cut, print in pieces, and glue together. I want to avoid this because (1) it's an air intake path and leaks will be an issue, (2) I don't know what glues/sealants will be safe, and (3) I want to learn how to do this correctly.
Creality K2 Pro, DXC2, MICROSWISS HOTEND
CREALITY PRINT V7.1.1.4472
OVERTURE PLA
NOZZLE 220C BED 50C
IN THAT SECTION PRINT SPEED IS 25-30
Default retraction .8 mm
I have a bit of a disconnect between Creality Print and my K2 Pro. I'm getting a TR2863 error on the Creality Print and K2 Pro. I disassembled the filament path and didn't find any fouling. Attempt to print again via the slicer and get a [FR0122]FR2358, but only on the slicer. I can manually start a print from the K2 Pro control panel.
The only way to clear the [FRO122] error is to hit ok, wait (no idea how long), and eventually it clears by itself. The error doesn't appear all the time. It's like a toss of the dice every time I start a new print.
I was really happy about getting a .456 until someone told me it should be .1. How do I run a bed mesh manually? Calibrate is greyed out.
Recovering from an Achilles rupture, so I have to minimize back and forth. Was planning to sit next to my K2 pro with a tablet and make changes.