u/Wilbarr

*I TRIED THIS WITOUT HOLDING IT ASWELL DOES SAME THING, JUST HELD IT BECAUSE I CANT RECORD ME FLYING EASILY

So just bought another new air75 and when I set it up and tried to fly it it was flipping over instantly and saying runaway so I went into beta flight and the flight controller was all wack in the 3D model so I adjust that so the 3D model accurately represents how my drone is oriented. But still like the video shows I arm it motors start normally then when I throttle up and back down it just keeps going up and only stops when I disarm it so I had to catch it out of the sky. It doesn’t spin or do anything other than shoot up.

Here’s some things I’ve already tried/looked at
- Checked the motor and propeller direction physically and on betaflight. My motors are set as reversed because of propeller direction.
- checked to make sure the receiver throttle in betaflight was acting correctly, going from 1000 up and then back down to 1000.
- adjusted the 3D model, had to adjust alignment with the yaw setting to 225 for it to act correctly.

Please help this is super annoying and have tried and watched many videos. Feel free to ask any more about what I’ve done as I may have missed things I’ve tried. Thank you!!

So I just purchased a 2018 340xi 6speed, it’s got the mppsk package which is Dinan tuned. Absolutely love the car but I would love some more sound out of my car and power increase of going catless downpipe. My question is, if I buy a catless downpipe (was thinking the vrsf but open to recommendations) and keep running the dinan tune that’s probably not going to give me much of a power increase because it wasn’t tuned to that. Also can’t really adjust much with the dinan tune that I know of so I was thinking of just getting an mhd tune. Let me know what you think I’m very new to this. Thanks

Looking at buying this 2017 bmw 340xi has 44k miles with the m sport package, that hit a deer a few years ago and has been repaired, main concern is the roof damage, got sent pictures of the cars roof as it is right now and looks good but questioning if this is a good deal or not as it’s quite a far drive to check it out.

I guess I crashed my drone one too many times and the black wire on my camera broke, this wire is super tiny so I’m wondering if anyone’s got a good solution to strip and re attach the wire. Thanks

Hey Mazda speeders, I’ve got an 08 Mazda speed 3 and I was replacing the valve cover and gasket because i think it’s leaking, the valve cover I have is broke on some bolts aswell but I purchased one off of eBay and realized it wasn’t correct I think it was for just a Mazda 3. I was wondering if there’s any place I could purchase one with this specific curve in it so it can fit my engine. I’ve only seen used ones.

Recently my drone is getting constant RX loss so I think my ELRS is cooked the antenna looks fine on my Air75 2 and was doing some research and saw I can put an external one on by soldering it, but the videos I see are for the older flight controller and wondering if I can install one for the newer FC I know I’m supposed to solder to the 5v and GND but idk where the RX and TX is. Any help or if anyone’s done it and has some insight thanks!!

So I’ve done some research on this problem and it seems like I’m going to need to buy a new flight controller cause mines done :( but it doesn’t seem to have any visible damage but it’s constantly losing and gaining telemetry and not able to fly at all. Is there anyway I can fix this without buying a new flight controller? Cause if that’s the case I think I’ll just buy a whole new air75 for 50$ more so I have more parts at that point.