Did I install this right? Nexus Lower - Atrius Forced Reset Selector - Super Selektor
I wanted to check with others that have done this before to make sure I've assembled the lower part right. I'm relatively new to AR builds but have a really good mechanical aptitude.
I bought a Atrius Forced Reset Selector - Super Selektor for the Nexus Lower.
When cycling through the safety positions, the safe works properly, as does the single fire. There's also the very satisfying click moving between safe and single.
However moving it to the third safety position, the selector indicator is a "off" by about 15 degrees and there's no click. Is that because I haven't attached the upper and trip kit yet?
I did not that when installing it and testing the alignment. The detent pin got kind of bound and it looks like there's a tiny bit of mechanical damage to the selector. Should I be worried ? It's a few tiny scratch marks, but the grooves look okay otherwise.
Outside of the damage, is everything Good to Go or should I consider sending this to a smith?