Hey all, working on this Searay 240 and removed all decals and now am onto compounding and polishing. I’m using 3d ACA 500 for my compounding step with a wool rotary. It got off most of the oxidation but I can still see the decal ghosting where the dark blue is. Any advice or tips? Want to avoid sanding as this was supposed to a be a quick project but I do want it to come out looking good.
Hello all and thanks in advance, recently I went on vacation and had shut down my 2021 MBP 16” with full battery and left it off for 2 weeks stored inside its case in my room.
When I came back and tried to power it on I had issues where the screen would go black and the trackpad and keyboard would not respond.
After restarting the laptop a couple of times I was able to log in and use it but I got a lid angle sensor message, when i have not replaced or touched any parts. Now randomly it will do the same thing where it thinks the lid is closed, and the screen goes black and keyboard/trackpad will not respond.
A couple minutes later it will work again and will repeat the same process randomly. Has anyone had luck with just replacing the lid angle sensor, or could this be a software issue?
I got into recovery mode and reinstalled Tahoe but it’s still doing the same thing. Any help would be appreciated!