▲ 1 r/FixMyPrint
Wobbling and failing mid print vertically
Hi, my print is slightly too large for the bed, so I’m trying to print it vertically. At mid print its starting to fail. I cannot print it at 90 degrees cause it s too big too.
The support if enabled even at 1 thresold angle will support the piece at the end when the failing already have occured.
This filament test was dryed before printing.
I don’t know which settings are relevant for this on bambu p1s.
Bambu pla used
Nozzle 0.4 standard flow
Noozle temp 220c
Plate temp 55c
Wall loop 3
Normal speed
u/coggia — 2 months ago
▲ 2 r/synology
cannot access to dsm after adding my admin account to docker group
Weird as it is, it's exactly as I wrote it,
I add my admin account in the docker group permission, and as soon as it applies i get kicked off the dsm.
I try to reconnect, i get access to the login page, password, 2FA and once i enter it all, I got a message box telling me that i'm not allowed to use this service..
Nice, cannot go back to DSM now. Got access to ssh but that's all, restarted the nas, same thing.
u/coggia — 4 months ago
▲ 1 r/batocera
X arcade tankstick problem on v43
I ve downloaded the v43, worked fine; but after a few restarts, the tankstick wasn’t recognized as a paddle like before bit was now in a new section (keyb/joy convert something like this)
Cool but now it s not recognized anymore as a paddle so it s impossible to use it in any of the retroarch configs.
Config a new pad doesn t detect that i press keys on tankstick. So i cannot add it.
The keys arr detected fine if i press them in the key/joy convert, but it s disabled in every emulators.
u/coggia — 4 months ago