u/danzmangg

I just bought this bike and it came with this rear rack. I ordered a basket from amazon to put on the back, but it seemed to be expecting a type of rack with holes in it that you can put screws into so you can mount it. As shown in the photos, this doesn't have those kinds of holes.

It instead has a spring-type mechanism that seems to be designed to keep its payload on via friction. What kind of basket should I look for online to work with this type of rack?

I'm not getting the X-planes (Hypersonic) contract for some reason, I think I've completed the requirements for it, and the "All" section of Mission control says that I have it unlocked, but it doesn't show up in the "Available" nor "Active" section. I also haven't seen it in the Archives. Any idea how to fix this? I think this might have happened after the buggy ContractConfigurator update came about.

Turned off standard fly-by-wire here since someone on the RP-1 discord suggested to use MechJeb Smart SASS instead.

Using a Thor-Agena LV. The readouts tell me that I can make the 150 x 150 km orbit with dV to spare, but when I get to the Agena stage it just stays facing prograde until I get a huge suborbital trajectory. Why is it wasting dV like this?

I'm using the MechJeb Dev build, which makes me use PSG instead of PVG. When using it, for some reason the second stage of my Thor-Able LV turns itself around, points itself to retrograde, then turns back around to prograde.

I have no clue why this might be happening, as I don't see any settings or anything to stop this from happening. Is this an Attitude Adjustment issue?

Trying to do the 3000 km downrange tutorial, but the spin motors always make me spin out too much. I initially had them on the bottom of the top rocket, but the spin out was the worst there, so I then tried putting them where they are in the video, which is in between the wet and dry CoM. It's stable at first, but then goes out of control over time.

I only tilted the spin motors by one "snap," like the tutorial said, and my snap was at 15 degrees. I tried at 5 degrees and it still didn't work.

Did this happen to anyone else?