u/filthy_762

Hi all, back with another obscure and niche question. I’ve come across a Colt 723 upper that’s I am looking to grab but a little confused as there are no C and forge marks on it. Where the Colt C and forge mark would typically be is just blank. The seller is reputable and claims that it is a Colt police trade in, but I’m skeptical because I can’t find any definitive answers on if Colt ever produced a C7/723 upper without markings. Any info out there on this?

Hey all, I have a question regarding the LMT 37mm barrel mount flare launcher. I can’t seem to quite find the info I need on mounting. I am trying to figure out if it is possible mount the 37mm barrel mount to a Colt 6920 SOCOM (14.5” p/w barrel with a FSB and KAC rail) and still be able to have the top KAC rail intact. I’ve seen a few photos, but most of them were from posts 4-5 years old and I couldn’t quite tell if the LMT 37mm they were using were rail mounted or barrel mounted. The ones I saw were LMT 37mm mounted on 6920 SOCOM rifles. Any help would be appreciated. Thanks everyone!

Hey all, I have a question regarding the LMT 37mm barrel mount flare launcher. I can’t seem to quite find the info I need on mounting. I am trying to figure out if it is possible mount the 37mm barrel mount to a Colt 6920 SOCOM (14.5” p/w barrel with a FSB and KAC rail) and still be able to have the top KAC rail intact. I’ve seen a few photos, but most of them were from posts 4-5 years old and I couldn’t quite tell if the LMT 37mm they were using were rail mounted or barrel mounted. The ones I saw were LMT 37mm mounted on 6920 SOCOM rifles. Any help would be appreciated. Thanks everyone!

Hi all, I think the answer to my question is that what I’m thinking is not possible, but I just want to 100% confirm. I originally wanted to do a P&W Gordy rifle out of a pre ban PWA commando that I just picked up, but … but know it’s not possible unless I used a mid length barrel, which I don’t like the look of.

So my question is, is it possible to use one of the adapter muzzle devices that’s p&w to a 14.5 barrel (instead of the 3 piece collar) and an AEM5 or OCM5 and get a somewhat similar look, or would there be too much gap between the FSB and the suppressor and it would look stupid? It’s seeming that the answer is that a 14.5 p&w cannot be done and nothing would look right.

I would normally just F1 SBR with no problem, but I’m unfortunately in VA and we aren’t sure if we will still get F1 approved or not after July 1st, so there’s potential I wouldn’t be able to F1 it. (Still going to file one on it anyways just in case). Just trying to figure out if there are any other options to achieve what I want to do. Thanks all!

Anyone know if the VB6 works on the noveske 6 arc 14.5 reflex rifle? Assuming that it should, but does anyone have any photos on the VB6 on one yet? TIA!