u/flyhmstr

~10h outage yesterday (3pm - 1am) which is always a bad thing, however it looks like for major scale incidents they've got their act together with emails sent from support first confirming there's a major outage impacting the user (I'm assuming they can map CRM location info with impact location information), then a couple of updates before the confirmation that everything was back about an hour after my network came back online.

Credit where it's due, that is the way to handle major incidents

Yes the bed was clean and the filament dry...
Now we've got that out of the way :)

An oddity which I've identified while debugging an adhesion problem printing the pastamatic. One piece has been lifting at one end, managed to get a print done, but the base is curved a bit.

On a hunch I checked the temperature of the bed using the IR thermometer I have for chocolate work, it's consistently 5C or so below the target temp across the bed with mroe of a variation nearer the edge (which is where the lifting was happening)

Before I raise a ticket to get support's view anyone seen something similar?

A1, Sunlu white PLA tried using both the Bambu PLA Basic and Generic PLA settings.

With the 0.4mm nozzle everything is fine, however when I put in the 0.2mm nozzle (HIKUDIY link below) it extrudes some and then the mechanism starts clicking before giving up.

The hotend screws (front and rear) are tight, did them today because I was noticing some issues with the 0.4mm.

Yes the nozzle setting is changed at the printer, I've also tried rebooting after changing to ensure everything has come up clean.

Any ideas / pointers?

[1] https://www.amazon.co.uk/dp/B0D1XHWJHH?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
[2] Let's deal with the obvious questions :)
Yes I washed the bed (fairy liquid, I have a dedicated sponge which is only used for that and it's cleaned and heated before use. The filament is dry and the moon and stars are properly aligned.