wondering measurements for the ks pro paddles, i currently use the es wheel and have just enough room between the shifters and my screen, wondering if the shifters stick out the same amount or if its different.
was driving the lamborghini gt3 evo2, had just came out of pits(fresh tires and refuel) 3 turns out car randomly turned off? didn’t press ignition or starter, wouldn’t let me start the car back up until i returned to garage and waited 3 minutes. not sure what happened, i had light damage on the left side but nothing else.
i assume it’s an emergency escape, or where antennas are? wasn’t sure where to post this, the gt3 sub is locked lol
me and my buddy built this with about $150 of materials, (including way too many bolts and screws lol)
will have to cut those 2 pieces sticking out above the wheel, but other than that, i think it’s pretty dope
due to a snowboarding incident i have permanent nerve damage from left hip down, leg shakes a decent bit when under pressure, making me unable to trailbrake properly, is there anything you guys think could help?
Update: Thank you everybody for your input and suggestions, (greatly appreciated) i think im gonna keep practicing(the problem came up when i upgraded to a load cell) if i can’t adjust i’ll probably go for one foot for brake and throttle
the whirring only happens when the wheel is calibrating(spinning like in the video) in beamng, haven’t noticed it anywhere else, i’ve had the base for about a year, only used it for about 7 months(been in storage as i moved about 5 months ago) it works as it should in other games, just worried about the noise