The border that goes around my monitor is a wee bit too big and covers a bit around the edges of the monitor.
I know I can change the POV of tables to make it fit better, but looking for something a bit more global and can also help while in Windows itself. It is hard to navigate when the taskbar is hidden.
Looking to pull up the old carpet in my house and have hardwood floors installed.
All I know are the big box stores.
Anyone have recommendations for a company that we can get the flooring from and have them install it?
Not sure we'll be able to match the existing flooring in half our main floor but ideally getting a match would be nice.
Shawnee side of town if it matters.
Currently with LifeMD for my medicine and about to go into maintenance.
I pay $450 for 6 month membership and $300 a vial. My 6 month plan is almost up.
Right now I'm shooting 20 units each week, so approx 2mg. (5mg + 0.6mg) 2ml. I never really had to take large doses.
Can one easily switch to a new provider, cheaper than current plan?
I assume I will need a new script from whomever I go to?
How does this work?
Do I just go to the sticky post and pick one?
My Whirlpool WRX735SDBM02 ice maker starts dripping after a few hours and I'm not sure why.
I thaw everything out and put it back in and it seems OK. Then a few hours later, after several cycles I'll notice that it is dripping and all the ice in the tray begins to freeze together.
The ice cube tray show no sign of corrosion or cracks and sitting with water on the counter it is not leaking.
I am not sure if it is needing a new water inlet valve because (1) it is making ice and (2) it doesn't immediately start leaking.
Not sure if it needs a new ice maker, because the thing still looks good and does make ice.
I did try adjusting the fill screw on the front of the unit, but I don't know if I am going the correct direction or turning it enough. And since it isn't instantly leaking I don't know if that is it.
Any ideas of what to do to fix it? Do I start with a new water inlet valve and then if that doesn't change anything a new ice maker?
Do I turn the fill screw clockwise to lower the level, or counter-clockwise? Is it a big turn or small turns? Or is this not even it?