u/katorce

Here you have two benchies, one white (the old one) and one in nicer filament. I am not sure if the issues exactly happened after I changed the fillament, I don't think so. The problem as you can see is that the printer struggle to make circles.

It is very evident in the chimney of the benchy, but to be honest with you, any other gap for a screw or similar has a similar issues in which the filament does not make a circle.

Any suggestion what shall I look at?

(It is the same gcode, but the bed temperature and filament temperature was increased to the match the middle point of the range of the new filament.)

Ender 3 Pro: Direct Drive
Orca Slicer
Filament with issues: PLA SILK Tricolor (Aurora Borealis)
White filament: Amazon Basic PLA
Nozzle (Aurora): 215ºC
Nozzle (White): 205ºC
Bed (Aurora): 60ºC
Bed (white): 50ºC
Print Speed: 100%
Retraction setting: I am unsure what this is so I guess Orca Default.

Is this how the minimap should be seen. I have found to be extremely hard to see anything, it is the same on every planet and I can't barely use it to see anything or guide me.

I have look at other screenshots or videos and the minimap does look much better and clear.

Compare with a picture I have found online where everything is clearly visible and not so fade out. https://preview.redd.it/are-we-meant-to-see-places-of-interest-while-scanning-the-v0-78eax64m49sc1.jpg

So I basically can't convert anything that has several folders mbox into eml. My option is go manually one by one, or, use a single mbox and lose the folders.

I am using the ImportExport NG.

I actually don't mind using a different software, as long as it is open source.