Hi. Just got this boat. 115 mercury. It's on the lowest/first hole. The tail reduces a bit when I trim up the motor. However the twin roosters tell me there is an issue. Thought?
Updated with video to show the issue better issue of transom
Trying to determine what knot is best/thinnest for attaching tuna cord to swivel on my downrigger. The knot doesn't pass though the guide on the 1106.
Knots I have tried.
Fisherman knot.
Uni knot.
Loop knot.
Loop knot was the closest for overall diameter... Bit still too thick to pass through the guide.
Anyone able to provide ideas?
I thought about just crimping, but I can't locate any double barrel crimps that would be suitable either.
Running a transducer from transom up in a harbercraft / kingfisher 19. Pulled the cover, but the well really blocks the ability to get at the wire . Does anyone have any tips on feeding the cable and getting at it other than a coat hanger?
I have seen a few different ways to rig these days and would welcome some debate and opinions. I'm often confused when to use a metal connector Vs just tie diect.
Jigging
Line - bead to snap swivel.
Gear - barrel swivel - 3 feet line - lure
Trolling with spoon style
Line - bead - six ball bearing - snap swivel
Gear - flasher - connector - snap swivel - line - tie directly to spoon ????
Trolling with hoochie
Line - bead - six ball bearing - snap swivel
Gear - flasher - tie direct to the connector with perfection
I'm really confused at times if and when to use hardware Vs perfection ?
Looking at the regulations regarding fishing in areas like 29 around Bowen etc.. the regs say no more than one hook on the line. Does this mean you can only fish with a single hook on a hoochie? So you need to cut the second hook off if it comes preloaded?
I got an update from Xiaomi a month or so back. Ver 3.0.8.0. WNLMIXM.
Since then typing jumps around on the screen and the keyboard gets fucked up when replying to messages. Anyone else experience this?
I got an update from Xiaomi a month or so back. Ver 3.0.8.0. WNLMIXM.
Since then typing jumps around on the screen and the keyboard gets fucked up when replying to messages. Anyone else experience this?
I made a mount / pedestal for a boat seat.
My print settings were petg HF (Bambi).
I used 4 walls. With 15 fill.
The fit was great. Unfortunately leaning back in the chair resulted in catastrophic failure.
Essentially the failure was it ripping like a bandaid off the base.
What improvements could I have made here to make this print stronger? I feel like I screwed up in a few ways.
My thoughts...
Instead of essentially mounting the cylinder adapter onto a flat base, have sink it into the print, providing more adhesion?
Thanks.
Can anyone provide their overall happiness with public mobile coverage here in town? I'm using virgin and the coverage seems to have really gone downhill.
My livewell keeps filling while travelling under speed. I plugged the drain hole and immediately this started pushing water from the higher drain. Anyone know what might be going on? Doesn't seem right to me that this would happen. I believe it is a flow rite system 2.
Hi. Is there any plan to release a firmware update beyond 1.07 that can support the firmwares >= 1.10 from BBL? I haven't been able to update printer firmware since 1.08 for quite some time now. I hope this post makes sense.