u/maddogg3166

Barrel has been fit!
Next is extractor/ejector/firing pin stop fitting!
Then lots of blending….this combo is going to require a lot of blending especially in the grip/safety area. Fire up the Dremel!!

Barrel fit next
Excuse my disaster of a work bench 😂

Guys did this swap awhile ago
It’s not that hard if you’re handy with a dremel and file! Fits Icarus/cheeley grips pretty well. Metal grips completely change the game on these guns. Still uses Bul magazines. If you want to use 2011 mags you need to modify the frame pretty extensively or do a frame swap!

And it starts all over again!

Accuracy-X slide,
D2 customs comp,
Jarvis barrel,
Infinity ignition/trigger,
Atlas small parts,
Cheeley grip,
Brazos frame

Major blending done, serrations done time for Test fire!

Got my next build underway. Short block was built by Josh @ A-Zone Precision. Just need to fit my atlas safeties, and it should be ready for test fire. I’ll be adding some rear serrations myself along with coating and finish blending. Going with Silver CRN with black barrel, grip, magwell, controls.
What do you guys/gals think?

Got a black infinity trigger installed!

Island Build!!!!!
🤔🤔🤔
Not what rear serrations and what Color to finish?
I’m thinking all black DLC with bronze controls and magwell!!

I can’t stop looking at it!!
🥹🥹🥹
What are your thoughts on the Green Vulcan Trigger? I ordered a black Infinity trigger just in case!

Just got it back from coating!!
You know where I’ll be for the next couple hrs!!
💪

Well it’s going off to PVD America next week for DLC/PVD coating. Going for the Peanut butter cup inspiration from Infinity. Should I keep the green trigger or go with black?

What do we think?
Got her all blended, cleaned up, put back together, and oiled

Well I got all of the small parts fit!
It racks like butter!
Time to Test fire and tune baby!

Still need to fit the lower on the barrel. Then onto small parts fitting. It’s coming together!