Star Wars Fans, I call to you . . .
Hello everyone, this is my first attempt to make a homemade lightsaber from some plumbing and hardware so forgive the crude design.
In the beginning, I had no intention of making this fully functional until I made it and really liked how it turned out, the only issue is that I have never dabbled with electrical components and there is not a lot of space in the hilt's cavity as the main body is a pipe with a 0.5" diameter.
I would like to buy a blade for it that matches the opening diameter of 0.75", length of 0.75" and secure it with 6 screws that can press it against the central pipe securely (function over form initially). I would like to have the lens, RGB LED, and Heatsink directly underneath, followed by the control button (this area has a diameter of 0.5", length of 7.5"). This would be connected to the bottom of the hilt with wires to the controller and battery (diameter 0.75", length of 1").
This is about as far as I think I can go before asking for some advice. Here are some of my questions:
> Is this setup possible given the tight dimensions?
> If so, what would I have to order to make this possible?
> Are there any resources I could be pointed to to assist me in the assembly?
Any help or input would be appreciated since I am very much out of my element but an excited to give it a solid try. Image descriptions are below, thank you! Future plans to wrap the O-ring grip area with some cloth and weathered black paint job to give some extra character.
- Diagram w/dimensions, desired component locations
- Full shot in-hand
- Top-down view (status if blade not attached)
- Top-down view (piece removed to make way for blade)
- Underside view
- Underside view (hilt bottom removed)
- Desired Button location/bore hole (located slightly above where it threads in to the main body)
- Desired Screw locations/bore holes (centrally located on each of the top bolt's surfaces)