I’m using orca slicer and I’m printing on a cobra Neo two. Speed is.In the 10-15 range, no retraction, .4 nozzle with .2 standard for the process.
From what I understand, I might be having some geometric constraints that are causing the stringing at the top. Otherwise, I’m very happy with how the print has turned out. I would just love to get rid of the stringing
I think I was noticing too much tension on the filament as it’s coming through the extruder I’m feeding it from below through a heater not sure if that could be causing the issue, but I noticed when I put lack on the filament a lot of the issues seem to resolve. Is there something I’m missing settings wise
From what I’ve been reading, I’m pretty sure this is a bad thermostat or cable to my bed. I guess I should probably replace the hot end first and see if that solves the problem? Then take apart the printer and see if I can find a wire what’s the likelihood? It’s just the hot end.
I know I’ve seen these posts before I don’t really seem to understand what resolved this for people anyone could help. I’d really appreciate it.
I just swapped the the hot end for a new one because I think I had a clog and suddenly this issue started happening. I don’t understand what caused this cause that was the only thing I changed and I did not touch anything else.