u/rubenmartins123

I redesigned my Gaggia MDF grinder with several improvements. The original magazine is completely gone, and the entire grinder is slightly tilted to prevent ground coffee from remaining inside the machine. I also integrated a scale into the base, which allows the dose to be controlled with a precision of 0.1 g. The whole case is 3D printed.

Hallo, ich habe diesen defekten Fenstergriff und weiß nicht wie ich ihn austauschen kann. Er ist an diesen zwei plastik Stiften befestigt und von der Rückseite sind keine Schrauben erkennbar. Er bewegt sich aber kein mm und auch hebeln mit Schlitzschraubendreher hat nichts gemacht. Ich tendiere zum ausbohren aber habe angst den Rahmen zu beschädigen.

Hallo wir müssen das Wasser abstellen um die Duschamatur abzumontieren. Der knauf am Wasserzähler lässt sich nicht drehen, kann aber abgezogen werden. Lässt sich dort das Wasser abstellen oder muss ich das woanders machen?

Hello, I'm Ruben, the inventor of the BeerCounter.

​

Some of you may have already seen my design or one of my previous posts here on Reddit. After receiving a lot of feedback on my latest release, I made several improvements since my last post.

​

I have now created two new versions to make the BeerCounter accessible to more users:

​

Fully 3D-printed version – requires only a few additional hardware components such as screws and rubber bands.

Hybrid version – uses the mechanism from a commercially available push-button bottle opener that can be ordered online. My printed parts enhance the opener with the BeerCounter counting mechanism. Unfortunately I was not able to find a supplier for the opening mechanism itself so I am not able to provide a kit with all parts included.

​

Another major improvement is the new counting system. Many users experienced issues with the previous design, so I completely redesigned it. Instead of supporting only 3 digits, the new mechanism supports 4 digits, allowing you to count up to 10 times more drinks before the counter resets.

​

There is still the problem that you need to remove a gear to reset the counter but usually there should be no need to reset it often.

​

I'd love to hear your thoughts and feedback!

Hello guys, I invented this lid clip for 750 ml Titanium pots. It can be 3D printed. Do you think people are interested in this?