u/schmebjulock

Half my screen decided to just be red?!

It otherwise works, my mouse can be seen even on the red side. I think its software, because my Windows install on the second NVME still works. So since I wanted to anyway, I just reinstalled everything and switched to Zorin just because. But it happend again.

Has anybody any idea on this? Why would it happen again after a complete wipe?

Thanks

Additional Info: My second screen works normally It is now black but still the same issue

Solution: https://www.reddit.com/r/zorinos/s/yb87YxuDjB

That was very quick, thanks to everyone. Apparently it was bad firmware and I needed to roll back an update.

I feel like these walls are printed not to the standard I know from other Bambu printers, but Im not sure. I know from even the A1 series that I sometimes couldn't even tell they were printed, because the layers were stacked so perfectly, even with standard settings.

This issue only really shows itself under specific lighting but I tried finding the same on prints from an A1 at Uni and didn't.

What do you guys say? You can insult me too if this is a stupid question, then I at least know my printer is fine :)

​

Additional Info:

I have the X2D for about a month now and I dont know if this is me being overly observant or if there is something wrong.

I have experience with 3d-printing and also with Bambu printers, but this is the first Bambu Lab printer I own.

Never much calibrated my old printer because I didn't expect a ton of quality and only printed functional parts.

​

Everything is clean, I retentioned the belts, the printer has a bit over 100 hours, the Filament is dry and pretty new.