u/sparkymark01

Is anyone really struggling at the minute with printing? Currently trying to print in petg, i genuinely spent the guts of a whole day trying to calibrate my printer to print petg. At first i printed the thing i needed before the bed temps, it printed it ok but i knew i could get better.

The test prints eventually got it to what i was happy with so i tried my hand to print and it literally turned out worse before the calibration.

Then i calibrate AGAIN, printed AGAIN and messed up AGAIN so im at a cross roads right now. I used Klipper to get the bed mesh spot on and it was as good as i could get. Printing also at 240 degrees and 75 for the bed temp...idk im losing it

Is anyone running a safe set up for this board? Not looking to turn to the max but an optimised set up?

Or has anyone found the absolute sweet spot in set up?

As someone who has played console my whole life and just got into PC gaming, what is the most logical way to game going forward with discs now being taken away?

I brought my board to my local tech store as I got a loose cap resoldered, he noticed blank pads but looking on this page I see that is normal.

Does anyone have a picture or direct me somewhere so I can see the full complete PCB?

I should say I am waiting for a PSU and fan, I’m afraid now if I plug everything in it will completely brick the system

Any help appreciated