u/Annual_Key_4963

AR-15:
Some barrel, seems fine but looking to replace it in the future
VKTR BCG (this make a huge difference in gas)
Geissele SSA-EX
Atibal Optics 1-12 LPVO with Plumb reticle (strange)

AR-10:
Criterion 416 Nitride w/ rifle length gas
Trijicon 6x ACOG 308 reticle

u/Annual_Key_4963 — 11 days ago

▲ 1 r/Firearms

Shooting-safe ambient mic/monitor for IEMs

I have a set of custom molded in-ear monitors that work much better for sound protection than any hearing protection I can buy for shooting. I'd like to be able to utilize these like you would any other pair of Walkers, etc. where I can hear what's going on around me but the audio cuts out when shooting.

I can't seem to find any such device in the searching I've done. Does such a thing exist?

reddit.com

u/Annual_Key_4963 — 15 days ago

▲ 220 r/Firearms

New trap gun

New IWI TS-12 with a Meprolight red-dot/laser combo up front to work as a dot/psuedo-bead sight :D.

It seems to inspired responses.

u/Annual_Key_4963 — 20 days ago

▲ 38 r/Shotguns

Mazel tov! Let's go trap shooting

IWI TS-12 with a Meprolight dot/laser combo

u/Annual_Key_4963 — 21 days ago

▲ 0 r/lasercutting

2A 50BMG

u/Annual_Key_4963 — 1 month ago

▲ 0 r/Laserengraving

Faster wat to perform cut through

I'm attempting to perform some cuts through brass.

I've had success with figuring out shape fill settings that reliably get through the material.

It's clear that this "fill" wastes a lot of time as I really just want the shape cut out (the laser is wasting time removing waste material).

I've not had much success using "line" as a means of cutting out the shapes however. It seems to just weld and takes much, much longer than the "fill."

I assume that I need to mess with wobble settings? Can anyone recommend good ones?

Settings for fill on 50w galvo fiber:

40hz, 500mm/s, 80% power (not pushing higher)

Fill: crosshatch, 90 degree, dot width

Line: what do?

u/Annual_Key_4963 — 1 month ago

▲ 89 r/Laserengraving