u/Beadlocks

Information is for educational purposes only. If you’re willing to be a beta tester, report results please.

You know where to go

Black only, without HBI buffer.

Had the common AMS internal hub failure. Got a replacement internal hub, however filament would not feed the full length to the print head.

The AMS had recalibrated itself to feed to the point where the broken AMS internal hub gears started slipping.

You will need to recalibrate this manually. There are no settings to do so.

*Take off the print head cover and disconnect the ptfe tube.

*At the back of the printer disconnect one side of the boden coupler (one side black, one side blue).

*Push filament through the AMS to this point where you disconnected. Once you can grab it, pull an extra 2-3 feet out past the end of the ptfe tube.

*Manually feed this through the printer’s internal tube to the print head. Pull slack through, and cut filament with an extra few inches past the end of the tube.

*Push filament into top of extruder. And reconnect the ptfe tube to the print head.

*Reconnect the boden coupler at the back of the printer.

*Start a new print. At this point the AMS will retract the filament through the entire tubing run, simultaneously resetting the length of which it needs to feed back to the print head.

If there’s still issues past this point you may need to check for cleaning the hall sensor inside the AMS feed mechanism (the one with orange gears).

Hey all, needing to pick up an OEM 43x slide. The entire upper, barrel and all.

Does anyone have positive experience with parts re-seller websites; such as Glock slide USA, oem Glock slide?

Have been searching on GAFS for used, but just want a source I could buy new if need be.