Drive cycle

Drive cycle

Anybody know how long after disconnecting a battery would the drive cycle reset to ready I changed a purge valve two days ago and disconnected the battery to reset the code but I went today to try to pass emissions test and I was rejected because it's reading not ready.

u/DapperLeopard3167 — 4 days ago

Refund on an old inactive card

If an old card on file is charged and u request a refund will it go through even though the card on file is no longer active? It was still somehow able to charge my bank account.

reddit.com
u/DapperLeopard3167 — 8 days ago

Purge valve

Anybody ever change the purge valve in the rear under not the one in front by engine, need a step by step how hard is it I have an evap leak and I'm suspecting it's that one.

reddit.com
u/DapperLeopard3167 — 19 days ago

Under the air filter housing

Noticed this is not connected I'm pretty it's missing a middle piece in between can anybody confirm

u/DapperLeopard3167 — 1 month ago

2010 tsx 2.4

Just today it started to struggle to breath while idling like it wants to cut off then at a red light it turned off 9j me but came right back on , I only have EVAP codes for check engine light which are for a purge flow

reddit.com
u/DapperLeopard3167 — 1 month ago

Caster is a bit off

How bad do y'all think this is, was recommended to replace the lower control arm

u/DapperLeopard3167 — 2 months ago

Suspension

Anybody that knows about suspension, anything look off or damaged? Recently hit a curb feeling a little paranoid, rim didn't take no damage only tire

u/DapperLeopard3167 — 2 months ago
▲ 6 r/MotoG

Moto G 2026

I recently got this phone and it won't let me login into my Cash app I keep getting this error code, anyone here deal with this issue before or know how to bypass this

u/DapperLeopard3167 — 2 months ago

Joint for purge valve

I've been having a evap code for a leak for while I noticed this joint that runs behind the purge valve has a little bit broken off on the corner could this be the cause for the evap leak ? Also has anybody ever replaced this piece I was considering just adding JB weld to that little cracked off corner.

u/DapperLeopard3167 — 3 months ago