It started up fine then about ten minutes later it stopped starting. It hasn't started since. The battery voltage reads fine. I hear what I think to be the fuel pump clicking. The starter is getting power. But I don't hear anything from the starter. Does anyone have suggestions?
Got a thermal runaway code so I got a new extruder head after disassembling the old one and not finding anything. Now it's doing the same thing on the new extruder head. Set it to 220 for pla and at later 2-3 it dropped down to 194. Put it up to 240 for a second and it steadily rose again. I'm keeping it at 230 right now and it's working fine. But if it happens again what is the best course of action
The blue will weigh about 700 lbs. The green about 400. The red about 250. And the table on the left is about 800
I recently acquired this bobcat 225 nt and was wondering what I needed to get it adapted for mig and tig use. Is it just the wire feeder for mig and the torch for tig?
Edit: what feeder should I use. It looks like it needs a ring style connector rather than a 14 pin connector like the new ones
I recently made a business account and I'm using the card reader with elavon that was included. I've signed in and made a payment. The payment has gone through into my US bank account but it's still saying I need to take a payment or else I'll lose ability to take payments and need to reapply. Any one know why this is