My epg keeps failing when updating?. My Strong updates fine. But Trex keeps failing. The channels all work. I have tried with my VPN off and on?.
Any suggestions would be appreciated.
Peace.
Seller accepted the return. Finally sent the label on the last day before asking eBay for assistance. I shipped it back, and it is now sitting at their post office awaiting pickup.
Is the seller just trying to waste as much time as possible before refunding?. What would be my next step?.
Thank you in advance.
Peace.
I was wondering if anyone can help getting UHF server on my qnap TS464. I have never used a docker, and so I’m pretty confused on how to even start?.
Any help would be greatly appreciated.
Peace.
I have Tailscale on my Qnap, and it is working. I have been reading about setting it up as an exit node?. I tried to ssh into it and run the commands, and it didn’t work?.
When I use putty to ssh it opens a menu, and no commands worked?. When I opened a command prompt on my laptop with ip and bash it has just a prompt.
I tried:
echo 'net.ipv4.ip_forward = 1' | sudo tee -a /etc/sysctl.d/99-tailscale.conf
echo 'net.ipv6.conf.all.forwarding = 1' | sudo tee -a /etc/sysctl.d/99-tailscale.conf
sudo sysctl -p /etc/sysctl.d/99-tailscale.conf
And
echo 'net.ipv4.ip_forward = 1' | sudo tee -a /etc/sysctl.conf
echo 'net.ipv6.conf.all.forwarding = 1' | sudo tee -a /etc/sysctl.conf
sudo sysctl -p /etc/sysctl.conf
From the tailscale install page?.
I’m not sure what I’m doing wrong. I’ve only ssh’d once before. So I’m not sure if I’m missing a step.
Thanks in advance.