u/FlexiTV

Hello i have seen that the Lenovo x3550 m5 has a place where i can connect a 6pin pcie cable to it is there any specific cable i need to use or can i use any normal 6pin by 6pin cable? The header is also labeled as GPU. I have attached a picture of the header

Hello im currently using my anycubic kobra 3 max i have calibrated the flowrate and this is how my prints look they have small gaps and a line in between is there fix for that

Thank you in advance

Hello im using my Kobra 3 max and all of my first layers have these problems shown in picutre im using it completly stock and printing the esun pla + filament

I have small gaps in my first layer

I have made this mesh after bed tramming with my bl touch all corners where either on 0.01 or 0.00 im using mrsicoc

Im having massive under extrusion or something i have done the following

Changed nozzle to 0.6mm

Changed bowden tube

Disambled the whole extruder then cleaned it and calculated esteps

Setup my slicer setup flowrate setup pressure advance

Cleaned print bed

Cleaned even the hotend

Leveled bed

Switched firmware from mrsicoc back to official firmware and then back to mrsicoc

Im running out of ideas

Im print the esun pla+ at 230C nozzle and 55C bed

I also leveld the Z gantry

I have a extreme case of layer lines how could i fix it

Im currently running only 1 z motor

Any help would be appreciated

Thanks in advance

Edit: I also already calculated the E steps and i also have a new ruby nozzle installed

Im having a problem im doing the trim bed first then i create a mesh and then i do the z probe wizard. But when i want to print something it always fails because either the noozle is too low or its too high

A picture of the mesh bellow

I really dont want to sell the printer and want to use it as my main production unit

I have just pulled this card i have bought this booster from a shop near me are they genuine. As far as i can tell they seem pretty real but i want a confirmation