▲ 10 r/Mk3Supra
Send cams as is?
I know these are normal to happen for the 7M cams and all that. Can I take a 1000 grit very fine emery cloth without screwing up the oil pressure, or just send it as is?
u/Florence86 — 12 days ago
u/Florence86
▲ 4 r/EngineBuilding
Rtv to mating surface?
Jb weld or Rtv? Noticed a nasty gounge for the front/crank main seal is. Wondering if that'll create a oil leakage for me.
u/Florence86 — 21 days ago
Working at Tesla or a Pharmacy distribution?
So, I got an interview at this Pharmacy place about 10 minutes from where I live, but I also had a recruiter reach out to me about a position at a Giga Factory in Sparks, Nevada. Anyone work in either both or one of those industries? Heard alot Pharmacy is very strick, since it's Fda while everyone is trying to get a gig at Tesla. Good pay and environment for both?
u/Florence86 — 1 month ago
▲ 14 r/EngineBuilding
Get new bearing?
Developed a scratch on con-rod 2 after torquing down to check oil clearance. Best to replace or attempt to polish down?
u/Florence86 — 1 month ago
▲ 9 r/Mk3Supra
A way to tackle this rust?
Any good chemical spray you recommend? If not, cutting/grinding down, and adding patches of tack welded sheet metal.
u/Florence86 — 2 months ago
▲ 17 r/EngineBuilding
Need to send back?
I got my block and engine back from the machine shop today. Questioning what I got back. Prepping for an MLS gasket 1.4mm. Seen scratches and corrosion on the water jackets. Send back?
u/Florence86 — 2 months ago
▲ 1 r/Autobody
Corroded areas. 1989 Supra
Best way to tackle these corroded areas? Was thinking of cutting out the sections and tack welding sheet metal to it. Think 18-20 gauge. Thoughts?
u/Florence86 — 2 months ago
▲ 1 r/millwrights
Anybody in here a member of local 1090 Monroe? Looking for companies that will take a 1st year apprentice. Going to be making calls starting Monday.
u/Florence86 — 4 months ago