u/Franzix98

Hi guys,

i'm going to buy an atoto s8 for my honda civic from 2005.

Has anyone here already installed it and can tell me what I need? Maybe some adapters or something like that?

this is not my car :)

Thank you very much!

Hi everyone,

I have a Klipper on my FL Sun Super Racer, and for the past few days I've been having the following problem.

Completely at random, Klipper shuts down with the following error: Lost communication with MCU ‘mcu’. It does this when the printer is idle, never while printing. It usually happens within the first few seconds after connecting. I took a look at the logs, and what I found strange is:

bytes_retransmit=9

It seems that Klipper is trying to connect to my Robin Nano 3.1 but can’t, even though it successfully established the initial connection.

My Raspberry Pi 3 is inside the printer’s case and has no cover. It’s connected to the motherboard via a USB cable that runs from inside the case to the outside. Additionally, there’s a 12-volt step-down converter from the power supply to power an LED strip (which isn’t controlled by a relay). Does anyone have any advice for me? I’m going crazy.

Thanks so much!