u/Fugi95

So I have a 2008 seadoo gtx 215. It has the Siemens ecu in it. I had just put a new fuel pump in it and went to start it and it turned over a few times and started but was running rough. We pulled the plugs to check all three cylinders for spark and as we were testing the machine turned off. Now when I put the DESS key on it simply powers the display on that says seadoo and briefly flashes the hours but NO KEY BEEP. We have changed the main relay and have rigorously tested all fuses and grounds and power lines to no avail. No idea what else it could be. When I hook my computer up to the seadoo to read the codes etc it says no ecu. Any idea which direction I should go next in diagnosing this? Any info at all is appreciated.

I currently have a 2dof motorcycle simulator that I’ve been building with an actual motorcycle frame. I am using 24v wheelchair motor as with a sabertooth motor board and an arduino. I get everything moving succesfully and am able to play games but for some reason when playing games sometimes the motors will suddenly start pulsing heavily and the only fix is to unplug the usb and hit the emergency power off switch for the motors. It’s super frustrating and it happens usually with inn 3-5 minutes of playing. Last night I finally tried reprogramming the smc3 settings and made the clip range much larger and then it actually did help and I was able to play a full race but after the second race it happened again. Has anyone had issues with this? I wonder if it’s something to do with inertia and it hitting the clip limits and the smc3 settings.

Any info is appreciated. Attached are my smc3 settings.

Seadoo gtx 2008 no beep

Motorcycle Race Sim 2dof smc3 pulsing issue