u/GINJAWHO

Trying to come up with ways to keep my garage cool during the summer and easy to remove when I move

Just curious cause this is the only thing I wish my truck had. It already has heated seats and I know it would require some reprogramming which I would have to take in but preferably I'd like to be able to install it myself since I'm cheap

Edit: 2026 silverado

I've seen alot of people complain about the wireless android auto connection issues on here so I've just accepted that I'll have to restart my head unit every so often if AA doesn't start even tho it's connected to my phone, but I havnt really found anything about audio issues. My audio just cuts out for like half a second to 2 seconds every know and then. I would take it in if it happened going over a bump so they can find the loose wire but it doesn't onky happen then so I'm not sure. Wondering if anyone else has had a similar issue and if they were able to fix it

I'm on an Intel 14900kf and a 7900xtx gpu. I'd prefer to not fully shut down the computer just incase I forget to save somthing. I'm also running an AIO and I don't want the pump running 24/7

Its getting annoying listening to it tab on the glass while the Extruder is going and I'm not sure if there is a way I can reorientate it to keep it from hitting the glass or if I just need to get somthing between the glass the cable guide.

So first off, I've ran thru all the calibration options in orca, retraction for me is confusing cause idk if I need to change the length or the speed, my temp tests have poor bridging with layers drooping, I'm also getting angle hair on my prints and filament oozing out of the nozzle after every print. Other than the calibrations iv done a Pid test and a bed mesh cal. Am I missing somthing? I can't for the life of me figure it out. My filament is dry, I bought a dryer thinking that has been my issue and while it has gotten better with the dryer, I'm still having these issues.

Part of my wonders if I fried a board? The reason I changed to a microswiss is because my nozzle clogged with petg and while I was trying to clear the clog with my printer on and nozzle heated I did somthing cause it shut off and I smelled an electrical smoke smell but everything seems to be working. I think I touched the two bronze temp wires together or they touched the cooling fins on the original hotend, I'm not sure. I'm open to any suggestions right now