
Another notch on my rifle
Took a few shots because it was at the top of a cedar tree

Took a few shots because it was at the top of a cedar tree
So I’ve been practicing shots with the Harpex pellets: Aquila, pro hunter x, and Quantum at probably 24 ish yards, (that’s the distance I’ll need for chipmunks and red squirrels at the cottage), and it’s dead on accuracy with my Beeman Raider .22 at 800 FPS and 40 joules ish, just gotta hold the gun really tight to my shoulder as I’m built like a string bean but even after 5+ shots it’s accurate as hell and it punctured 3/4” wet piece of plywood that’s been used as a fish fillet board for a few years, I looked it up and apparently that’s 2x what I need to kill a raccoon with a headshot
So I bought some Harper Combo Pack 4 .22 200 count of Aquiles, Zeus, Pro Hunter X, and Quantum, and when they got here one looked like it had been run over by a stampede of elephants, (exaggerated), but still, should I send it back or open it and check the contents?
P.S I have opened the can, the pellets are fine as I shot some yesterday and super accurate, I am using a Beeman Raider .22 at 800fps and 40 joules so I need heavier pellets and thought these looked pretty cool, and all pellets I have fired from this brand have been all accurate.
Langley Fisherman’s DE-LIAR scale and tape measure, in not so good shape and was in my grandpas possession till a few days ago and I’m scratching my head in how to repair it. The tape is stiff/stuck and I’d rather not pull it out until I got some good advice, the spring is heavily rusted too and I’m wondering what’s the best limited budget option for cleaning it out?
Is there anyone who can help me by soloing the fume knight? I can equip a greatshield and keep to the edge, I’m a veteran player but I’m not very good at boss fights and just love to collect all the weapons/armour/etc. thanks in advance for your help 😋
Is this the infamous sms nickel? It seems more matte and lack of features than a regular one 🤔🤔🤔
Trying to help a cop with a fugitive, non lethal takedown of said criminal, cop starts swinging…. 😑😑🤔🤔 I usually take off when cops get angry but I’m very tempted to smack this one around 😅😅
I have finally figured it out, my Beeman Raider .22 has 28 joules/781 FPS with a 21.14 grain/1.37 gram Baracuda Match, I had to do a lot of head scratching and taking apart and putting back together, there was a limiter in the barrel that was preventing full air flow, air leakage, hammer bounce/fart noise, so I removed it and almost shot through a piece of poplar 🤣 it’s super loud, probably the 28 joules but I’ll figure that out later as I now have a working fully powered PCP
So I gutted it again, and looked up how to stop hammer bounce, they said to put 2-3 o-rings between the hammer and the stick thing so I put 2 in and it’s still hammer bouncing but not cocking itself anymore, am I right to add another ring even though it misplaces the screw holes? I’m sure I can figure something out around it
So I drilled out the transfer port, the one that’s been modified at the factory to have a smaller hole and now it’s going goes “brrrrt” any ideas on why and how to fix?
So I bought the Robert Lane Regulator for my Beeman raider and I am super confused and they don’t seem to have instructions for pellet rifles and I wanna make sure I do this right so I don’t mess up my pcp, can someone pls help me with this?
Am I looking at the limiter for the Canadian Beeman Raider? Can I just remove it or do I have to drill a hole through it? I just bought it like maybe a month ago and I swear I could spit faster, 450 fps, pellets bounce off soft cedar even at point blank range and seriously need an upgrade which I do have
So the breach seal is getting worn down to the point of inaccuracy and the fps has dropped from 680 to 625, should I give it another good deep clean or just buy a whole new pellet gun? Because I cannot for the life of me figure out where around me they sell the right O-rings, the part number is B12-00-14 but two different options pop up and it also says it can take part number 130-036 but I am utterly defeated, I’m gonna try one of the suggestions from google which is flipping the seal around and seeing where that goes, can someone pls help me before it drives me mad? 😅🤣
Im from near Ontario, Canada, and in dire need of a new breech seal for my Crosman F11 .22 but unfortunately I can’t find anything online or near me, can someone pls help me find this part? Even if it’s from the UK air the USA, it’s starting to really mess with my shot pattern/accuracy
So I’ve had my crosman F11 for a year or more and I upgraded to the 60kg gas ram and it’s settling at 650 FPS/20 FPE and I’m wondering if I should replace it since it’s getting less powerful 🤔🤔
So I’ve just tried every kind of pellet I have at around 75 feet, can anyone tell me what I’m doing wrong?