u/Latter_Throat

K2pro. Out of no where printer won't start printing. It starts the calibration and stalls out and does nothing. One time it touched the bed and didn't go further. Or it will lower the bed all the way down and stop. Disabling the calibration allows it to start printing.

I've been avoiding updating because last time I did it was crashing the print head into the stops. I've updated it now and it didn't solve the calibration issue.

Any help would re appreciated

Printer has been working great for 8 months without issues.

Trying to hardwire my pelsee p3 dashcam with a fuse tap. I can't get it to work. It has good power and ground. I tried wiring it back up to the USB plug to make sure I didn't damage the wiring when I was running them through the car and it still works. Any advice would be greatly appreciated. Tried multiple fuse locations tried flipping the fuse tap even tried a different fuse tap. It has both fuses in it.

Ruckus died while out for a ride today. Has been super consistent lately untill I had my valves adjusted. I'm wondering if that has anything to do with it.

Healthy crank. Battery is new and at 12.6 carb is getting fuel. I cleaned it out, even cleaned the permanent jet.

I confirmed spark. Running 38/75 jets as that is what was working best for me. Has CDI, aftermarket intake. Swapped spark plugs as mine looked a little fouled and it sputtered a bit more than the previous plug

Could the valves be set too tight? It rode home from the shop after the adjustment. It rode fine for a quick trip yesterday and then died after about 20min today.

Any advice would be appreciated I feel like I've gone thru all the troubleshoot