u/LuthersCousin

Safariland holster finder is absolutely no help. I keep winding up at the page for a DS Prodigy. Is this the same holster model?

I need a holster with the Safariland hole pattern that preferably has active retention. Prefer to stick to an actual Safariland holster. Will be for a 4.5F that will end up with a threaded barrel and comp. - Can someone tell me exactly what model it is or provide a link? I know it's a 6390RDSO-572 but it never says "Echelon" anywhere.

I've considered getting a Ragnarok to hold me over but really don't want to wind up with another box full of holsters I don't use.

Thanks for any help.

I used one of those cheap adapter plates to mount my Predator 224. The plate is fine, but the hardware it came with is trash and one of the bolts to mount the engine stripped. I need to take the engine off but the nut just keeps spinning in place. I tightened another nut on the top to try to create enough torque to get it off, but the bottom nut just continues to spin in place, even when I hold the top nut with a separate wrench.

Apart from cutting it off, is there any possible way to get this nut off the bolt?

Does anyone know what size hardware is used for the adapter plates that mount a Predator 212/224 block to the GMB100, Doodle, etc? One of the screws stripped and I need to get some replacements.

Any idea the best way to get the nut off other than cutting? I was going to try tightening a second nut against it to see if there was enough torque to get it off.

Is anyone aware of a solid guide and video for clearancing all the parts in a Predator 224 stage 2 build? I'm having a hard time finding a good video. They either skip over it and/or the camera angles are trash.

What's the best for it? A Dremel?

Anyone have a good recommendation for an aftermarket fuel tank for a GMB100 frame that has around 0.5-1gal capacity?

Got the carb to do a swap this weekend. Bought some cheap grips with throttle cable, and jet kit. Carb comes with the intake adapter manifold, fuel filter and air filter.

will I need a new fuel line? I just thought of this when looking at the stock line that looked pretty short.

I don't have a fuel shut off valve, so I'll order one for the future...is there anything else of any necessity I'm overlooking? I haven't done a stage 2 on the engine and likely won't, so I did buy a tachometer to keep an eye on rpms. I'm not a total speed demon and don't imagine it will be an issue with how I ride it. After watching people do it on YT, I think I'd almost rather just get a Studz Tillotson backyard bully and be done with it.

I have a Rep Nighthawk bench, but was originally considering getting a Rogue rack roller for my RM-6, primarily for Nordics and Bulgy split squats with a Yoke bar.

Now that Rep came out with the roller 2.0, wondering if I could get by with it as opposed to spending $400 after tax on the Rogue item.

Anyone have experience with both that they can share? Mainly concerned about the width of the bench for Nordics as opposed to just using a pad on the floor. I'm also not sure how it would work for split squats or not. Never saw anyone try it.

Who makes the best J-cups dollar for dollar that are compatible with Rogue Monster (3x3, 1")?

Just can't stomach $300 for a spare set of sandwich cups. BoS looks pretty decent for $141.

I've seen some of you guys that use old license plates as a mid flap/fender off of the rear of the frame. Are you guys just bending them and welding to the frame?