u/MUWAT_toro

How do I rename a project from the default "unnamed"? Is that forbidden when using it for free?

About every other print my K2+ pauses at the beginning of the print with error AC0123: the printer plate is missing. Any filament. CFS. No CFS. Doesn't matter.

Well, the plate is there.

I press resume and it prints fine.

Firmware 1.1.5.2

2200 hours

Microswiss hotend.

It has happened intermittently for months. Before I put on the microswiss. Prior firmware versions too. The plate is clean. The cameras are cleaned with IPA on a qtip.

Why is it doing this and how can I prevent this errant error?

I dont know what the name of it is, the top plastic part that covers the printhead cable and has the top pivot point for the drag chain.

Is there a replacement available or a file to print one?

Also, does anyone have a source for replacement screws for it? I dropped one and it is now in the land of unpaired socks.

Can I turn off the tank heater so I can use less than the minimum level of resin? I have less than 1/2 a bottle of e pensive resin I would like to use. It is probably 70 dollars worth I dont want to waste

20013ish z445 with the Briggs engine. About 150 hours. I got it in 2019 with 10 hours on it. It turns over but will not start. New battery, fully charged. If I hit it with a spray of starting fluid it starts up and runs fine.

It just wont start on its own or run at idle well. I have cleaned the carb, verified the fuel shutoff solenoid. New fuel and air filters. New fuel pump. New plugs and coils. All are OEM branded replacements. New start solenoid and key switch last year.

Once started it runs like a champ for as long as needed....unless it shuts off, then the starting spray comes out again.

What do I look at next? Could it just be the starter getting slow?

I have a DXC2 for my k2+ that I have been delaying installing because of some reported heat creep issues. Does that happen with the microswiss hot end? I've read that the MS product is less problematic, would the upgrade combo be prone to the heat creep?

Since the DXC2 extruder seems to have a bit of an issue with heatcreep when printing high temp filaments i thought I might upgrade the heatbreak fan. Is there one that moves more air? Does ducting help? What might help prevent heat creep?