u/Most-Following-433

So I updated the temperature and retraction settings on the filament, updated rate and pressure for the white. It did improve in my eyes, but I'm still wondering if there's any more improvement to be had ? Maybe it's how the model is set up in the slicer ? Any recommendations, will be appreciated.

Ironing on
Filament dried
Flow rate, pressure, temperature and retraction all done
P2S Combo - Bambu Studio
Green - eSun PLA + (with preset)
White - GIANTARM PLA (with preset)
0.4mm Nozzle
0.20mm Standard @BBL P2S Process

In the slicer:

I have the cube part and then I set the logo as a modifier part inside the cube model itself, and matched the top layers. That is all I have done. If I assemble them, the parts of the logo that are "in the air" materialize instead of going on the cube, hoping you guys understand what I'm saying.

Any ideas/suggestions to get a better finish than this?

Filament is dried, flow rate calibrated, ironing test done and settings applied.

I don't love the diagonal lines and the roughness. There are also a few imperfections on the middle squares, I'd wish to get rid of. The top corners on the faces also are sometimes a little roughed up.

P2S
Green filament eSun PLA+
White filament Giantarm PLA Matte

Hello guys, I recently ordered the new x2d and I came across this post about someone doing 7 color prints with very little waste with their H2C. I would like to know if anyone can help me figure out what techniques or settings I can implement to execute these prints and achieve similar results. Anything you guys can mention will be gladly useful and helpful!

Post: https://www.instagram.com/reel/DT8-fhdkVAP/?igsh=MW1pcTI5MDdnM2M5bg==

For any information, proof, help, please feel free to message me and I'll help out with everything you need for the transaction.