Does anyone have experience with using the Ford Performance tune with bolt ons? I currently just have the 3” Thermal R&D and eventually plan on maybe doing the CV Fab intercooler. I’m wondering if anything like these could mess up what it does or make it better? I really am not looking to squeeze all of the power out of it, so I wasn’t really looking for something custom. Thanks.
Not sure of the find location, but the state was Iowa. I tell my friend to keep an eye out for these and he sent them. Unfortunately, no store had the hat. Does anyone have more information on that?
Took the Telly about 320mi round trip this weekend. It’s a ‘27 SX P X-Line AWD HEV with about 1800 miles on it. Ran into moderate traffic with spouts of standstill. Also a couple pit stops where the car was just running idle for ~20mins so the numbers really impressed me considering the AWD variant is supposed to be about 30. I did the same trip about a month ago and couldn’t get above 28 but it seems that now the motor is broken in. Figured I’d share my stats. Yes I know the screens are incredibly dusty looking. I still have the protective film on the screen and didn’t even realize the dust was there until I took a picture from an angle.
First time messing with this system, let me know what you think! I'm probably going to keep adding to it. Maybe add a waffle fry or a sandwich/biscuit.
There is a fun thing going on another subreddit where people vote for a state to be “consumed” by another. Each day the state with the most upvotes gets absorbed by another until there is one winner. Virginia has recently become the target of Maryland and North Carolina to be taken out and we could use some counter votes to help keep Virginia going! I tried to counter with VA taking over MD, so if you find that one upvote it or find another we can band together on!
I ditched the H test and went with the I to fit more in. I did 13/15 needles as 2 weren’t run atm and it’s hard to access at the moment. I think I am dialed in on the 33/33/33. Let me know what you think and if I should do anything else. The number is the needle, the arrow on the right side was the direction the test went and the check at the bottom is the one I think is best/locked in. Do you agree? Thanks!
Starting to do some tests to see if I can learn and make sure my machine is in tip top shape for the best results. Realized at the end the white would probably be tough to tell. The blue I think turned out the best. Both white and orange are ok but struggled a bit on the middle line. The black struggled the whole way and broke the thread a few times.
Can you please suggest what I should do from here? My machine has two knobs for top tension. One by where the thread first gets pulled in and another once it goes down the plastic line at the top of the head. Thank you!