i dip this print with 3 different level of ipa where the last jar is almost new.
is it because i didnt wash it long enough or is it because i didnt scrub the print before curing it?
these "wet mark" only appear at the lower part of the print and the top part looks much more cleaner than the bottom part.
few hours into psy and notice that her damage falloff is so bad that the only viable way for me to play her is behind tanks. so most of the game i ended up with lots of unnecessary damage block when compare against other dps because of how closeup i need to be to even be effective.
tried flanking, but it wont do much against good players because they listen to footstep alot so i rarely do this.
sorry for asking so many questions at once and thanks for the reply in advance.
the first 2 pictures shows the base of a print coming out slightly bended, and getting more and more bended after some days. i hollowed it out in the slicer, is this why it bended more and more over time?
the 4th pictures shows the surface of the base, and it looks like there are some "grunges" on it which should be totally smooth. my process is taking the print out of the printer, remove the supports, wash it for 10 minutes in resin, and then cure it for 10 minutes. is this normal? or is there anyway to improve the quality of it?
there are some "holes" in the print where there are supports for it. did the holes appear there simply because it is too "thin" for that area? should i just manually make the mesh of that area thicker? my exposure time for each normal layer is 12s, last picture with red circle is where that "hole" appear.
thanks for any reply in advance.
noticed that there is a "hole" in my print and only found this after doing vat clean.
doesnt feel any bump on the screen protector nor there is any resin underneath the screen protector.
is it possible to have so many dead pixel at once? or should i disassemble the screen and check?
李老师报道，6月19日，河南郑州宏达国际车业广场发生火灾。
据网传视频显示，现场火势猛烈，多栋建筑被大火吞噬，火光冲天，浓烟滚滚。有附近居民称，燃烧范围疑似波及三个以上区域。
as you can probably tell, this is a pretty small print. and in the red box, there are some tiny parts that dont have support or doesnt connect to any of the main print.
should i just add support to all these tiny parts? or is it ok if i just ignore these and just print it?
and if i choose the just print route, what will happen to these tiny parts that is very likely to get cure and stick at the fep instead of the main print? will it cause printing failure at the following future layers?
link: https://www.reddit.com/r/Malacca/comments/1u4pw42/remaja_maut_digilis_lori/
"AYER LIMAU 13 Jun - Seorang remaja lelaki maut selepas terlibat dalam kemalangan membabitkan tiga kenderaan berhampiran sebuah masjid dan sekolah di Sungai Siput, Lubok China. Dalam kemalangan kira-kira jam 1.30 petang itu, mangsa, Muhammad Muiszudin Mohammad Yusof, 14 meninggal dunia di lokasi kejadian. "
look at them, a duo who play together and win 40/47 games only at level 20. i think that this duo has very high chance of being best player in marvel rivals, because they are obviously not smurfing nor bussing which can easily detected if netease wants to actually do something about smurfing and bussing
great future ahead for these 2 players 👍