u/Rhine_Labs

I Charge $170 + Ship For this Located In Vancouver WA USA.

I can Do the Following units.

This Repair will reset the unit to Unmarried Virgin. 1 Business Day Turnaround Time.

32109-08A (Black/Gold)
4-Pin J1850 Only
Open "Race" Calibration (Non-EPA) Up to ~2011/2012 models

32109-08C (Orange)
4-Pin & 6-Pin CAN-bus
Open "Race" Calibration (Non-EPA ) Up to ~2016/2017 models

41000008A / 41000008C (Black / White)
4Pin and 6-Pin CAN-bus
Restrained Street Calibrations (EPA Compliant)

Already Pulled the Dallas and X-rayed it.

Finally had some time to explore this Mid 1980's Data I/O Unisite Programmer 8MB Memory Expansion Board Spoiler was a Few PAL Chips. The next step is to solve the flash floppy issue of not detecting the disk change and corrupting the images. Blog post https://www.stevenrhine.com/?p=140193

A local Museum I volunteer at has this old Carl Zeiss Universal Microscope they would like to know the value and seekign a local buyer. They really do not want to deal with shipping and it's located in the Beaverton Oregon area. They are a NPO. I looked at it and its a bit It's Dirty controls are sticky old lube.

Microscope Meiji Techno EMZ-8TR

Impressions, Microscope is Built like a tank and the optics are exceptionally crystal clear everything is butter smooth should decades.

The Bad
USA After Sale Support is Horrible (You Are On Your Own for Accessory Configs) Also If It breaks and not covered under warranty good luck finding service or simple parts. Service info lube etc nope nada.

Meiji Japan did give exploded View of the EMZ-8TR Trinocular Area and a EMZ-5TR Head Exploded View but missing most the parts list said they don't want the 8TR Head Exploded view to be seen by competitor? so only sent the 5TR WTF? All a competitor needs to do is take one apart. (I am posting the info I have in the photos. May this help someone looking at design and build quality for informed purchasing.)

No Set Screw For Eye Pieces They Can Slip Out Easy and Rotate when using eye Guards requiring constant fiddling. I use tape to secure and fix them.

Photo port pieces are sloppy as hell.. Requires shim to get the proper alignment or ya get sever vignetting on one side seems a .08mm to .1mm thick completely around the objective where the c-mount slips over is proper aligns everything up.

Photo port Focus is PITA having to use the threaded tube This is especially a PITA if your PC is not close by.

Did i mention no human support for photo port accessories and their camera / sensor size list is very very outdated!

Eye Pieces are 30.5mm that means custom to meiji and they don't make any High Eye Point for it. Maybe should have went with a EMZ-8TRH?

The off the shelf 30mm eyepieces almost work but sit a few mm to high with diopters bottomed out they almost work I was thinking of having a machinist turn me some off the shelf down a few mm or make custom eye piece objective holders but need to learn optics length etc.

ChipWisperer Lite X-Ray of PCB...

I know a lot of tech's that wait and wait for used units to pop up.. no wonder there are just few of them from time to time. This should be illegal... Segger Contributes to the e-waste problem! https://www.segger.com/purchase/trade-in-program/proof-of-decommissioning

X-ray of a Harley Screamin Eagle Tuner.. Ill get the other revision x-rayed in a bit.